Huawei USG6000E Series Hardware Manual page 554

HUAWEI USG6000E Series
Hardware Guide
●
●
●
Tool
ESD bag
Installing The Hard Disk (USG6515E, USG6525E, USG6550E, USG6555E,
USG6560E, USG6565E, USG6580E, USG6585E)
Step 1 Remove the baffle plate from the hard disk slot.
Step 2 Hold the handlers of the hard disk and push the hard disk along the guide rails till
the hard disk aligns with the panel of the USG.
Step 3 Press the hard disk handler inwardly to restore the module.
Figure 5-27 Installing the hard disk (USG6515E, USG6525E, USG6550E,
USG6555E, USG6560E, USG6565E, USG6580E, USG6585E)
Step 4 After the installation is complete, perform the following operations:
Issue 08 (2022-04-20)
Wear an ESD wrist strap to protect the USG and hard disks from electrostatic
damage.
Hold the two side surfaces of a hard disk, do not touch the PCB board or
squeeze the hard disk, and do not vibrate, bump, or stack hard disks.
For mapping relationships between the USG and hard disks, see
Overview.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
Hardware
547