Huawei USG6000E Series Hardware Manual page 581

Hide thumbs Also See for USG6000E Series:

Table of Contents

HUAWEI USG6000E Series

Hardware Guide

Step 1 Insert an optical transceiver into the 10GE, or 40GE, or 100GE optical port of the

Step 2 Remove the dust cap from the optical transceiver.

Step 3 Before connecting an optical fiber, attach temporary labels to both ends of the

optical fiber for identification.

Step 4 Remove protective caps from optical fiber connectors, insert optical fibers into the

optical transceiver, and connect the fiber to the peer device.

Ensure that the TX and RX ports on one end of the optical fiber cable are

connected to the RX and TX ports (respectively) on the other end.

Issue 08 (2022-04-20)

The optical module has been installed.

Set aside the dust cap properly for future use. After optical fiber are disconnected for

maintenance, use the dust cap to prevent the optical transceiver from dust.

Ensure that the Tx and Rx ports are correctly connected.

5 Hardware Installation

Show Quick Links

Table of Contents