Table of Contents
Advertisement
HUAWEI USG6000E Series
Hardware Guide
Figure 5-16 Installing optical transceivers and connecting optical fibers
Step 5 Repeat
fibers.
----End
Follow-up Procedure
After you power on the USG, check the connection by observing the optical port
indicator. If the indicator is on or blinks, the link is connected or data is being
transmitted. If the indicator is off, the link is disconnected. Possible causes for the
disconnection are as follows:
●
●
Issue 08 (2022-04-20)
Step 1
to
Step 4
The optical fiber is improperly inserted. Pull out the optical fiber and re-insert
it.
The RX and TX optical ports are inserted reversely. Pull out the optical fibers,
change their position, and re-insert them.
Copyright © Huawei Technologies Co., Ltd.
to install all optical transceivers and connect all optical
5 Hardware Installation
529
Hide quick links:
Advertisement
Table of Contents
