Huawei USG6000E Series Hardware Manual page 588

HUAWEI USG6000E Series
Hardware Guide
not run the disk offline command. The following procedure guides you through
hard disk replacement while the USG is powered on:
Step 1 Ensure that all configurations are saved.
Step 2 Run the disk offline command in the system view. Wait about 30 seconds until
the system indicates that the hard disk stops working and then remove the hard
disk to be replaced.
1.
2.
Step 3 Install the new hard disk, see
Step 4 Run the disk online command in the system view and then the display disk
information command. If Filesystem Status is Mounted, the hard disk works
properly.
----End
Issue 08 (2022-04-20)
NO TE
If you remove and insert a hard disk without running the disk offline command first, the
hard disk may be damaged, data in the hard disk may be lost, or the system may stop
responding to services.
Use the handler to pull the hard disk out of the slot.
Put the replaced hard disk into an ESD bag.
Figure 6-1 Removing the hard disk (USG6515E, USG6525E, USG6550E,
USG6555E, USG6560E, USG6565E, USG6580E, USG6585E)
Copyright © Huawei Technologies Co., Ltd.
Installing the Hard Disk.
6 Maintaining the Hardware
581