Appendix 8 How To Use Melsec-Q Series Modules; Window Change In Cw Configurator - Mitsubishi Electric MELSEC iQ-R Series User Manual

Appendix 8
This section explains how to use MELSEC-Q series modules.

Window change in CW Configurator

Setting items in MELSECWinCPU setting utility used for MELSEC-Q series are changed to the following windows in CW
Configurator.
Parameter items
■"Points," "Start XY," and "H/W error time CPU operation mode" in "I/O assignment setting"
MELSECWinCPU setting utility
[I/O assignment setting] tab
[I/O assignment setting] tab  [Detail setting] button
■"Switch setting" and "Error time output mode" in "I/O assignment setting" , and intelligent
function module parameters
MELSECWinCPU setting utility
[I/O assignment setting] tab  [Switch setting] button
[I/O assignment setting] tab  [Detail setting] button
[System setting] tab
■Interrupt pointer setting
In CW Configurator, the setting for interrupt pointer is changed as follows.
• Setting the SI No. for an interrupt module is not required.
• "Interrupt Pointer" of an interrupt module must be sequential numbers. (Set I51 to No.2 and I52 to No.3 when No.1 is set to
I50, for example.)
MELSECWinCPU setting utility
[System setting] tab  [Interrupt event setting] button
How to Use MELSEC-Q Series Modules
CW Configurator
CW Configurator
CW Configurator
[Navigation window]  [Parameter]  [System
Parameter]  [I/O Assignment] tab
[Navigation window]  [Parameter]  [Module
Information]  [(module name)]  [Module Parameter]
[Navigation window]  [Parameter]  [Module
Information]  [(module name)]  [Module Parameter]

Appendix 8 How to Use MELSEC-Q Series Modules

A
APPX
291