Performing A Recovery - Mitsubishi Electric MELSEC iQ-R Series User Manual

Performing a recovery

The following shows the procedure for recovering Windows.
To recover Windows, configure a system which only includes a power supply module, a base unit, and this product.
After recovering Windows, start this product and check that no error occurs.
It takes approximately 15 minutes to recover Windows.
However, the time may be longer depending on the C drive usage capacity when creating a system image.
1.
Turn the power of this product OFF.
2.
Connect the USB memory where a recovery drive is created and the memory device where a system image is created to
this product.
3.
Hold the BUS RESET/Y STOP/Y OUT switch on the BUS RESET position to turn the power of this product ON.
This product starts in the USB boot mode and the "Choose the language" screen appears.
4.
Select a language.
The "Choose your keyboard layout" screen appears.
5.
Select an appropriate keyboard.
The "Choose an option" screen appears.
6.
Select "Troubleshoot."
The "Troubleshoot" screen appears.
7.
Select "Advanced options."
The "Advanced options" screen appears.
8.
Select "System image recovery."
The "Select a system image backup" screen appears.
9.
Select "Use the latest available system image (recommended)," and click the [Next] button.
The "Choose additional restore options" screen appears.
10.
Click the [Next] button.
"Your computer will be restored from the following system image :" is displayed.
11.
Check each item and click the [Finish] button.
• Date and time when a system image to be used for recovery was created
• Computer name to be created
• Location of a drive to restore
"All data on the drives to be restored will be replaced with the data in the system image. Are you sure you want to continue?"
is displayed.
12.
Click the [Yes] button.
"Windows is restoring your computer from the system image. This might take from a few minutes to a few hours." is displayed.
A recovery of a selected drive starts. Wait until the recovery is completed.
13.
After recovering Windows, turn the power of this product OFF.
Precautions
Once Windows is recovered, the version of a driver package will be the one when the backup data was created. If a driver
package of this product was updated by using the update function of this product, update the version of the driver package
again after Windows recovery.
9 MAINTENANCE AND INSPECTION
9.4 Windows Recovery
9
101