Appendix 2 Windows Event List - Mitsubishi Electric MELSEC iQ-R Series User Manual

Appendix 2
This sections shows the list of events that occur on Windows in this product.
Event ID Event type
0010 System
0011 System
0032 System
0064 System
0096 System
0097 System
0512 System
0513 System
0576 System
0704 System
0768 System
0769 System
0770 System
0771 System
2048 System
2049 System
2050 System
2080 System
2560 System
2561 System
2562 System
APPX
268

Appendix 2 Windows Event List

Windows Event List
Event Description
category
Information A service was started.
Information A service was ended.
Information A service was ended.
Information An event of the MELSEC function was registered.
Information Parameters have been updated.
Information Windows was started or the bus was reset.
Information The number of connected MELSOFT connection
modules exceeded the maximum number.
Information The TCP connection time-out was detected.
Information The Windows time has changed.
Information A notification of parameter update was received.
Information Current consumption of a USB port exceeded the
threshold.
Information A USB port has stopped working because its
current consumption exceeded the threshold.
Information All the USB ports have stopped working because
their current consumption exceeded the threshold.
Information A current consumption error was cleared.
Warning Sending data failed.
Warning Receiving data timed out.
Warning Receiving data failed.
Warning A minor error of the MELSEC function was
registered.
Warning An invalid frame (packet) was received from a
MELSOFT connection module.
Warning A unicast frame (packet) was received on the
broadcast UDP port.
Warning Receiving a frame (packet) from a MELSOFT
connection module failed.
Corrective action



For details, refer to the manual displayed as a link.










Reset the bus and restart Windows.
If the same event is registered again, the possible
cause is a hardware failure. Please contact your
local Mitsubishi Electric sales office or
representative.
Try again after a while.
If the same event is registered again, reset the bus
and restart Windows.
If the problem is still not resolved, the possible
cause is a hardware failure. Please contact your
local Mitsubishi Electric sales office or
representative.
Reset the bus and restart Windows.
If the same event is registered again, the possible
cause is a hardware failure. Please contact your
local Mitsubishi Electric sales office or
representative.
For details, refer to the manual displayed as a link.
Check if the connected modules and Windows
applications use any of the following system port
numbers:
• 5006 to 5100
If so, take the following corrective actions and try
again.
• Review the port number of the module.
• End the application.
Check if the connected modules and Windows
applications use any of the following system port
numbers:
• 5006 to 5100
If so, take the following corrective actions and try
again.
• Review the port number of the module.
• End the application.
• A line may be congested with packets. Try again
after a while.
• Check if there is any error in the connection of
the cable and switching hub.
• Check if the cable is disconnected.