List Of Errors Related To Functional Safety - Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual

Error code (HEX)
An unexpected error occurred in
0x80112405
S/W.
An unexpected error occurred in
0x80112406
S/W.
4.1.3

List of errors related to functional safety

NOTE
• If a timeout error occurs, set the FR Configurator2 to the offline mode. Check the connection of the communication cable, etc.,
and remove any error causing condition, then set it to online.
• FR Configurator2 shows the safety parameters of the latest inverter at the time of the FR Configurator2 upgrade. (For the
upgrade timing of FR Configurator2, refer to
different before and after a version upgrade (with functions added).
Error code (HEX)
Parameters of the inverter used are not
0x01A0000B supported by the existing version of FR
Configurator2.
0x01A00117
0x01A00217
0x01A00417 Safety parameter settings are corrupt.
0x01A00301
0x01A00303
*1
0xA001**01
*1
0xA002**01
*1
0xA001**02
An unexpected error occurred in S/W.
*1
0xA002**02
*1
0xA001**03
*1
0xA002**03
*1
0xA001**04
A communication error occurred.
*1
0xA002**04
*1
0xA001**05
An unexpected error occurred in S/W.
*1
0xA002**05
*1
0xA001**10
A safety parameter reading error
occurred.
*1
0xA002**10
*1
0xA001**11
A safety parameter writing error occurred.
*1
0xA002**11
*1
0xA001**12
*1
0xA002**12
*1
0xA001**13
An unexpected error occurred in S/W.
*1
0xA002**13
*1
0xA001**14
*1
0xA002**14
*1
0xA001**15
Any value out of the setting range cannot
be written.
*1
0xA002**15
Error message
Network error
Connected socket forced
disconnection
page 227.) The parameters' setting range, initial value, and numbers may be
Error message
Possible cause
Check that the GOT is connected to
the network.
Check that the GOT is not making a
communication in other connection
method.
Countermeasure
Upgrade FR configurator2 to the latest version.
• Retry the operation interrupted by the fault.
• Perform safety parameter clear.
If the problem still persists after taking the above measure, contact
your sales representative.
Please contact your sales representative.
Check the noise and wiring.
Please contact your sales representative.
• Retry the operation interrupted by the fault.
• Perform safety parameter clear.
If the problem still persists after taking the above measure, contact
your sales representative.
Please contact your sales representative.
Write a value within the setting range.
Solution
225
4. TROUBLE INDICATION
4.1 Error code
1
2
3
4
5
6
7
8
9
10