Changing Scale And The Graph Display - Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual

• Trigger standby state
Standby
Click [
to move to the pre-trigger state.
Pre-trigger
Once the data ratio set at the trigger
position is collected, it goes to the trigger
standby state.
Waiting for
trigger
When trigger conditions are satisfied,
sampling will start.
Sampling
Sampling stops when [
is clicked or when the sampling time has
exceeded.
Exit
3.4.5

Changing scale and the graph display

The scale and waveform data display of the displayed graph can be changed. The graph's displayed portion can be divided
into a grid of 10 vertical and 10 horizontal sections. The scale of the vertical axis and the horizontal axis can be changed by
setting a numerical value for each 1 divided grid.
It is possible to slide and display the selected graph up and down by calibrating of the 0 position.
The scale value displayed on the vertical axis changes according to changes in the vertical axis scale.
A
B
C
D
E
Start]
Stop]
G
Sampling setting and trigger setting are performed.
Data before trigger is being collected.
(Even if the trigger condition is satisfied
during pre-triggering, sampling will not start.)
Data before trigger has been collected,
and the system is waiting for the trigger
conditions to be satisfied.
When trigger conditions are satisfied,
sampling will start. Data before trigger
is collected until the trigger conditions are satisfied.
Sampling is performed.
Graph mapping is performed at the same time.
Ends the sampling.
H
F
1
2
3
4
5
6
7
8
9
10
141
3. FUNCTION
3.4 Graph