Password Change - Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual

The following dialog is shown when batch write fails due to an error of the setting value or the date and time of update.
Sym Function/description
Name
bol
Date and time of Shows the date and time when the parameters are batch-written to the inverter.
A
update
B Station number Shows the station numbers selected for batch write.
No. Shows the safety parameter number.
Name Shows the safety parameter name.
C
Setting value Shows the safety parameter setting value.
Inverter Shows the safety parameter setting values read from the inverter.
Setting value
D Check code
Inverter
E Help Help appears.
F Close Closes the batch write confirmation window without performing batch write.
3.2.4

Password change

The password registered in the inverter can be changed. Select [Password change] from the [Safety parameter setting (Z)]
menu bar, or [Password change] on the toolbar to display the password change window. The initial password is "000000".
Sym
Name
bol
A Password
B New password
C New password (repeat)
D OK
E Cancel
B
C
D
E
Shows the values calculated in FR Configurator2.
Shows the values calculated in the inverter.
A
B
C
Enter the current password. The password is masked with asterisks (*).
Enter the new password. The password is masked with asterisks (*).
Enter the new password again. The password is masked with asterisks (*).
Applies the change. The password change window will close after the change is successfully
applied.
Closes the password change window without changing the password.
A
F
D
E
Function/description
3.2 Safety parameter setting
1
2
3
4
5
6
7
8
9
10
117
3. FUNCTION