Procedure For Connecting Inverters Via Ethernet - Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual

3.12.4 Procedure for connecting inverters via Ethernet

Start from step 7 for connecting inverters via the CC-Link IE Field Network.
 Example
The following diagram shows the example of connection with two inverters. Inverter parameters are set to initial values. The IP
address of the personal computer is "192.168.50.100".
1.
Start FR Configurator2.
2.
Select [Ethernet parameter setting] from the [Tool] menu bar. The inverters connected on the network are
automatically detected.
3.
Check that the inverters have been detected. Select [Batch assign] for network setting.
NOTE
• If the inverters have not been detected, probable causes include the following.
The Ethernet cable is disconnected.
The inverter power is turned OFF.
Inverters are not found in the same segment (there is a router in between).
Inverter parameter settings are not set to initial values.
• Each inverter has its own MAC address and host name.
186
3. FUNCTION
3.12 Ethernet parameter setting function
Personal computer
(FR Configurator2)
Model Pr.
FR-A800-E
1427
FR-F800-E
1428
FR-E800-(SC)E
1076
FR-A800-E-R2R
1077
833
FR-E700-NE
834
Ethernet connector
Ethernet cable
Hub
Ethernet
connector
Inverter
Name
Ethernet function selection 1
Ethernet function selection 2
Ethernet function selection 1
Ethernet function selection 2
Ethernet function selection 1
Ethernet function selection 2
Initial value
5001
45237
5001
45237
31
20