Editing Parameter Setting Values; Verifying Parameters - Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual

Symbol
J Target item

3.11.2 Editing parameter setting values

The listed setting values can be edited from the file edit window. The file edit window can be shown by opening the USB
memory parameter copy file.
Symbol Name
A Title bar
B Model
C Parameter list
D No.
E Name
F Setting range
G Min. unit
H Initial value
I Setting value
NOTE
• Edited setting values are not checked when saving the USB memory parameter copy file or when writing to the inverter.
Therefore, even values that cannot normally be set to the inverter (setting range, write-limited values) are written to the
inverter. In this case, because operation of the inverter cannot be guaranteed, change setting values with extreme caution.
• To display the explanation about a parameter on the help window, double-click the parameter in the parameter list.
• Changing a parameter by FR Configurator2 may affect other parameter settings.
• When using the FR-A820-03160(55K) or FR-A840-01800(55K), do not change Pr.570 Multiple rating setting.
• Do not change the Pr.71 Applied motor and Pr.450 Second applied motor settings from an induction motor to a PM motor
or vice versa.
• Calibration parameters cannot be set.
• If the parameter name field is blank, do not change the setting.

3.11.3 Verifying parameters

A list of differences between the USB memory parameter copy file to verify (*.cp1) and the parameter initial values or the
parameter setting values of the verify destination file (*.cp1) can be displayed.
180
3. FUNCTION
3.11 USB memory parameter copy file edit function
Name
Specifies the column to search.
A
B
C
D E
Shows the file name of the open file.
Shows the model set by the file.
Shows the parameters of the USB memory parameter copy file.
Shows the parameter number.
Shows the parameter name.
Shows the setting range of the parameter setting value.
Shows the minimum setting unit of the parameter setting value.
Shows the factory default parameter setting values of the inverter.
Shows the parameter setting values saved to the USB memory parameter copy file, and inputs the
setting values to be written to the inverter. Setting values cannot be set as blank.
Function/operation
F G H I
Function/description