Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual page 225

Error code (HEX)
0x8011000B
0x8011000C
0x8011000D
0x80111001
0x80111002
0x80111003
0x80111004
0x80111005
0x80111101
0x80111102
0x80111103
0x80111104
0x80111105
0x80111106
0x80111107
0x801111FF
0x80112001
0x80112002
0x80112003
0x80112004
0x80112005
0x80112201
0x80112202
0x80112203
0x80112204
0x80112205
0x80112206
0x80112207
0x80112208
0x80112401
0x80112402
0x80112403
0x80112404
224
4. TROUBLE INDICATION
4.1 Error code
Error message
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
Communication was not
established with the inverter
within the timeout time.
The specification of the
communication port is incorrect.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
Communication was not
established with the inverter
within the timeout time.
An unexpected error occurred in
S/W.
Communication was not
established with the inverter
within the timeout time.
Communication was not
established with the inverter
within the timeout time.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
Communication was not
established with the inverter
within the timeout time.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
An unexpected error occurred in
S/W.
Possible cause
Protocol type error
Host name error
Socket port number error
Electromagnetic interference, etc.
are propagated when receiving
GOT software.
Serial line open error
Serial line closed error
Serial line setting error
Serial line baud rate error
• Occurred before starting the FR
Configurator2 or during
communication.
• Serial cable between the GOT
and the personal computer is
disconnected.
EZSocket GOT is installed, but the
file is broken.
• A cable between the GOT and the
personal computer disconnected
before starting FR Configurator2.
• The GOT power turned OFF
before starting FR Configurator2.
Electromagnetic interference, etc.
are affecting between the personal
computer and the GOT.
USB line error (at the GOT device
error communication ending)
USB line error (sending function is
invalid)
USB line error (receiving function is
invalid)
USB line error (cable disconnection
registration failure)
• USB line error (cable was
disconnected halfway)
• When a cable between the GOT
and the personal computer was
disconnected during
communication.
• When the GOT power turned
OFF during communication
The GOT was not found on the
network.
Socket line open error (socket
generation failed)
Please contact your sales representative.
Solution
Check for protocol type.
Check for the host name of the
connected GOT.
Check for the port number.
Set a larger value for timeout setting of
the software and try again.
Check for the communication port
setting.
Try again.
Try again.
Try again.
Connect the cable.
Install software again.
• Connect the cable.
• Power ON the GOT.
Set a larger value for timeout setting of
the software and try again.
Try again.
Try again.
Try again.
After reconnecting with the GOT, try
again.
• Check for cable connection.
• Power ON the GOT.
Check that the GOT is connected to
the network.
Check that specified port number is
correct and the IP address of the GOT
is specified.