Test Operation; Test Operation Window; Displaying And Switching The Operation Mode - Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual

3.9

Test Operation

The test operation function is not available for the following models.
Model: FR-A700, FR-B (700), FR-B3 (700), FR-F700, FR-F700P, FR-E700, FR-D700, FR-E700EX, FR-D700-G, and FR-E500
FR Configurator2 gives a start command to the inverter to start test operation. "Test operation" allows the selected inverter's
frequency to be displayed, operation mode to be switched and displayed, forward and reverse operation commands to be sent,
setting frequency to be written, and other functions to be done.
3.9.1

Test operation window

Select [Test operation...] in the [Test operation] menu or
Symbol Name
A St. No. (Station number)
B Operation mode switch
C Operation mode
D Operating status
E Operation command
F Frequency setting
G Run/Stop command buttons Sends the run/stop commands.
3.9.2

Displaying and switching the operation mode

To switch the operation mode, select the [PU], [EXT], or [NET] button, or select [PU(P)], [EXT(E)], or [NET(N)] from the
[Operation mode (Z)] menu bar.
164
3. FUNCTION
3.9 Test Operation
B C
A
D
F
G
Function/description
Selects a station to perform test operation with.
Switches over the inverter's operation mode.
PU PU operation mode
EXT External operation mode
NET NET operation mode
PU + EXT External/PU combined operation mode
---- Indicates that the operation mode information was not acquired properly.
No display Nothing is displayed when offline.
FWD Rotating forward
REV Rotating reversely
STOP Stopped
ALARM Being stopped by the fault
---- Appears when operating status information acquisition fails.
No display Nothing is displayed when offline.
STF During forward rotation command
STR During reverse rotation command
---- Appears when operating status information acquisition fails.
No display Nothing is displayed when offline.
Set the running frequency.
in the toolbar to display the test operation window.
E