Battery; Battery Specifications; Mounting Of Battery - Mitsubishi Electric Melsec Q Series User Manual

4
SETTINGS AND PROCEDURE TO OPERATION

4.8 Battery

This section explains the mounting and replacement of the battery.

4.8.1 Battery specifications

This section shows the specifications of the QJ71MES96 MES interface module battery.
Type
Initial voltage
Nominal current
Battery life when stored
Battery life when used
Lithium content
Application
Remark

4.8.2 Mounting of battery

The QJ71MES96 MES interface module is shipped with the battery connector
disconnected. Before using the module, connect the battery connector.
Connector
Battery
Connector fixing
MES interface module
Table 4.9 Battery specifications
Item
Manganese dioxide lithium primary battery
3.0 V
1800 mAh
Actual life of 5 years (room temperature)
Section 4.8.3 Battery replacement
*1
0.57 g
File protection
*1 The lithium content of batteries manufactured in July 2017 or earlier differs from this list. For
details, refer to the following.
Technical bulletin No. FA-A-0242
For the battery directive in EU member states, refer to Appendix 9.
1 Open the battery cover located on the bottom of the module.
2 Check that the Q6BAT is correctly installed.
3 Check the direction and securely insert the connector plug of the Q6BAT
to the jack of the module.
4 Close the battery cover.
• Firmly push the battery connector all the way in to the connector pin.
• When operating without battery mounted, refer to the following.
Section 4.9 Operation without Mounting Battery
Not following the procedure may cause the data corruption in the
CompactFlash card being accessed or a file system error.
Description
Q6BAT
4.8 Battery
4.8.1 Battery specifications
1
2
3
4
5
6
7
8
4
- 20