Mitsubishi Electric Melsec Q Series User Manual page 362

10
TROUBLESHOOTING
Error code
0D00h
0D01h
0D02h
0D03h
0D04h
0D05h
0D06h
0D80h
to
0D82h
100Eh
2000h
to
20FFh
4000h
to
4FFFh
7000h
to
7FFFh
9000h
9006h
9008h
9202h
9204h
920Ah
9920h
9922h
9923h
9E20h
9E81h
9E82h
9E83h
B000h
to
BFFFh
10
- 21 10.2 Error Code List
10.2.1 Error codes for the MES interface module
Table 10.3 Error codes for the MES interface module
Error name
Setting file out-of-range Access was made to outside the
access error setting file range.
New setting file creation
Failed to create a new setting file.
error
Setting file open error Failed to open the setting file.
Setting file seek error Failed to seek the setting file.
Setting file read error Failed to read out the setting file.
Setting file write error Failed to write the setting file.
Setting file close error Failed to close the setting file.
System error —
Errors detected by the access target CPU
User's Manual for the access target programmable controller CPU
Errors detected by the serial communication module
User's manual of serial communication module being used
MELSEC-L CPU Module User's Manual (Hardware Design, Maintenance and Inspection)
System error —
There is no available space in the
Send buffer full
send buffer.
System error —
The issued processing code cannot
Processing code error
be processed on the other end.
The device type specified for the
Device type error
access target station is invalid.
The device number specified for the
Device No. error
access target station is out of range.
Number of device points The device points specified for the
error access target station is out of range.
Errors detected in CC-Link System
CC-Link System Master/Local Module User's Manual
Description
• Turn the power OFF and ON, or
• Please consult your local Mitsubishi
• Please consult your local Mitsubishi
• Check the control CPU(s) of the
• Check the routing parameter set for
• Check if the access target PLC
• Please consult your local Mitsubishi
• Check the CPU(s) on the access
• Correct the device type entered in
• Correct the device number entered
• Correct the device points entered in
(From the previous page)
Action
reset the programmable controller
CPU.
representative.
representative.
network module(s) on the access
route to the access target CPU
module.
Section 3.2 (2) Accessible
routes
the CPU(s) on the access route.
series is supported.
Section 3.2 (1) Accessible
CPU modules
representative.
route.
[Device tag settings].
in [Device tag settings].
[Device tag settings].
(To the next page)