Mitsubishi Electric Melsec Q Series User Manual page 114

4
SETTINGS AND PROCEDURE TO OPERATION
(1) Stopping file access
(2) Installation of the CompactFlash card
4
- 17 4.7 CompactFlash Card
4.7.2 Installation/removing the CompactFlash card
1 Stop file access.
• Turn the File access stop request (Y2) ON from OFF.
2 Check the file access stop by the following:
• Check the CompactFlash card status (X1) is OFF.
• Check the File access status (X2) is ON.
• Turn the File access stop request (Y2) OFF from ON.
File access stop request (Y2)
File access status (X2)
CompactFlash card status (X1)
1 Open the LED cover on the front of the MES interface module, then remove the
CompactFlash card slot cover.
Figure 4.14 CompactFlash card slot cover removal
• Put the finger at the bottom of the LED cover that is on the front of the MES
interface module, and lift the LED cover to open.
• Put the finger at the top of the CompactFlash card slot cover and then
remove the cover.
(In operation)
Figure 4.13 File access stop processing
1)
(During stop)
2)