Configuring Ir Control Settings; Ir Illuminators; Smart Ir; Figure 4-7 Ir Control Settings - Honeywell 60 Series Configuration Manual

•
G.711 provides good sound quality and requires about 64Kbps. Select pcmu (μ-Law) or
pcma (A-Law) mode.
•
G.726 is a speech codec standard covering voice transmission at rates of 16, 24, 32, and
40kbit/s.
After you complete the settings on this page, click SAVE to enable the settings.

Configuring IR Control Settings

Go to Setup Camera SetupIR Control.
On this page, you can turn on the IR illuminator and adjust the luminance of IR lights.

Figure 4-7 IR Control Settings

IR Illuminators

Turn on built-in IR illuminator in night mode: Check to turn on the camera's onboard IR
illuminator when the camera detects low light condition and enters the night mode.
Turn on external illuminator in night mode: Check the connector type to turn on the
camera's external IR illuminator when the camera detects low light condition and enters the
night mode. You should connect an alarm output first.
The built-in IR illuminator function is not applicable for
Note
HC60WZ2E30.

Smart IR

Anti-overexposure: When checked, the camera automatically adjusts the shutter speed, Gain
and IRIS through algorithm of the firmware in order to avoid over-exposure in the night mode.
Configuring Camera Settings
27