Configuring Ir Control Settings; Ir Illuminators; Smart Ir; Figure 39 Ir Control Settings - Honeywell 30 Series Manual

•
G.711 provides good sound quality and requires about 64Kbps. Select pcmu (μ-Law)
or pcma (A-Law) mode.
•
G.726 is a speech codec standard covering voice transmission at rates of 16, 24, 32,
and 40kbit/s.
After you complete the settings on this page, click SAVE to enable the settings.

Configuring IR Control Settings

Go to Setup  Camera Setup  IR Control.
On this page, you can turn on the IR illuminator and adjust the luminance of IR lights.

Figure 39 IR Control Settings

IR Illuminators

Turn on built-in IR illuminator in night mode: Check to turn on the camera's onboard
IR illuminator when the camera detects low light condition and enters the night mode.

Smart IR

Anti-overexposure: Check to automatically adjust the shutter speed, Gain and IRIS
through algorithm of the firmware to avoid over-exposure in the night mode.
The IRIS control only applies to HC30W45R2/HC30WB5R2/HC30WE5R2
Note:
motorized focus/zoom cameras.
IR adjustment: Adjust the luminance of IR lights.

Figure 40 Smart IR

Manual IR adjust: Check it to control the luminance of IR lights manually. To increase
the luminance of IR lights, drag the slider to the right; to decrease the luminance of IR
lights, drag the slider to the left.
Honeywell 30 Series IP Cameras User Guide
33