Setting Up Live Video Streaming; Setting The Stream Type; Setting The Stream Protocol; Logging Out - Honeywell Performance Series User Manual

24 | Performance Series IP Camera User Guide

Setting Up Live Video Streaming

In the upper left corner of the screen, immediately above the video window, you can set the
stream type and protocol for live video streaming.

Setting the Stream Type

To set the stream type, in the Stream Type list, select Main Stream, Sub Stream 1, or Sub
Stream 2.
The properties for each stream type are configured on the Setup > Camera > Video > Video
page.

Setting the Stream Protocol

To set the stream protocol, in the Protocol list, select TCP, UDP, or Multicast.

Logging Out

To log out of the camera, in the upper right corner of the screen, click the Logout tab.
www.honeywell.com/security
Main Stream Delivers high definition video for real-time monitoring, recording, and storage.
Uses the most bandwidth.
Sub Stream 1 Delivers low/standard definition video, typically for remote monitoring in lower
network bandwidth environments.
Sub Stream 2 Delivers low, standard, or high definition video.
TCP Provides most reliable data transmission. Higher latency and bandwidth use
than UDP.
UDP Provides fastest data transmission. Lower latency and bandwidth use than
TCP but allows some data loss (such as dropped frames).
Multicast Provides the most efficient use of bandwidth if large numbers of clients are
viewing the video simultaneously.