Chapter 10 First-Time Setup - Cisco 3200 Use And Care Manual

Loading CTS Administration Software
Make sure that you power on all codecs within 30 seconds to avoid power on detection failure.
Note
After you turn on the codecs, the displays associated with each codec becomes active. CTS displays
green check marks on all displays to show bootup progress. Bootup is complete when the system
displays six check marks as shown in
Figure 10-1
If the last check mark displayed is a red "X," there has been a compact flash error. Please contact Cisco
Note
Technical Support.
After bootup completes, make a note of the IP address that displays on the center of the screen as shown
in Figure
IP address displays until you log in to Cisco TelePresence System Administration or use Secure Shell
(SSH) to log in to the CTS-3200.
Cisco TelePresence System 3200
10-2
Bootup Completed
10-2. You use that information to log in to the Cisco TelePresence System Administration. This
Figure 10-1.
Chapter 10 First-Time Setup
OL-14521-01