Removing Audio Components - Cisco 3200 Use And Care Manual

Chapter 12 Field-Replaceable Unit Guide
•
•
Cisco TelePresence 3200 Structure, Accessory, and Adjustment Assembly:
•
Tip
•
•
•
•
•
•
•
•
•
* Recommended for best results

Removing Audio Components

Caution Take care not to mar or introduce smudges or dirt to the surface of the projector screen.
Power off the system by completing turning off the following units:
Step 1
•
•
•
Make sure all system power is turned off before beginning this disassembly.
Caution
Remove the Projector screen by performing one of the following actions:
Step 2
•
OL-14521-01
* Safety glasses
* Box cutters
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
A round-head Allen bit allows the bit to work at an angle instead of only straight out, which is
helpful in tight spots.
Manual screwdrivers, Phillips and flat head types
Metric wrenches, 10 to 15 mm
9/64-inch Allen wrench (supplied with speakers)
0.9mm Allen wrench for camera lens adjustments (if the lens uses a thumbscrew no tools are
required)
Level
Masking tape
* Tie wraps
Laptop computer attached to network
* Step ladder
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
The auxiliary control unit on the center display structure
If your projector screen is slightly recessed and uses black side trims, complete the following steps:
Remove the side trims from the edges of the display.
a.
Be careful not to mar the screen when you perform this step.
Use an open-ended wrench to loosen the feet on the bottom of the screen, and lower the screen.
b.
Replacing a Plasma Display—Part Number CTS-DISP-65-GEN4=
Cisco TelePresence System 3200
12-7