Setting Up CTS Components
Figure 10-7
Correct Camera Target Alignment—Left Display
j.
Tighten the thumbscrew on the zoom and focus rings.
Step 5
Step 6
Click Hide Camera Target to remove the alignment images.
To complete the zoom procedure, click Done.
Step 7
Step 8
Click Setup, then click Auto Adjust to automatically adjust the camera settings.
You will see various images and colors on the displays during the adjustment. Auto Adjust takes
approximately 1 minute.
Focusing the Camera
To focus the cameras using the large and small targets, complete the following steps:
Place the small target on center of the table, in front of the center camera.
Step 1
Arrange the large target five feet (152 cm) behind the small target.
Step 2
Use a chair to prop up the large target.
Tip
Cisco TelePresence System 3200
10-12
Place the small target on the table, in front of the large target, and adjust the focus by completing
the steps in the
"Focusing the Camera" section on page
Chapter 10
10-12.
First-Time Setup
Red
Vertical line
Red plus
sign within
black cross
Red lines
Table
edge
OL-14521-01