Replacing The Audio/Video Extension Unit-Part Number Cts-Av-Exp - Cisco 3200 Use And Care Manual

Chapter 12 Field-Replaceable Unit Guide
Step 3 For the right and left vertical light fixtures, follow these steps.
a.
b.
Step 4 For the horizontal light fixtures, follow these steps.
a.
b.
Place the replacement light fixture in the bracket and secure with the screws.
Step 5
See
Plug the light fixture into the Auxiliary Control Unit.
Step 6
See
Turn the power switch on the Auxiliary Control Unit to the On position.
Step 7
Replacing the Audio/Video Extension Unit—Part Number
CTS-AV-EXP=
To remove and replace the audio/video extension unit for the Cisco TelePresence 3200, you need the
following tools and equipment:
•
•
•
Remove and replace the audio/video extension unit by performing the following procedure:
Power off the system by completing turning off the following units:
Step 1
•
•
•
Make sure all system power is turned off before beginning this disassembly.
Caution
Remove the cables from the audio/video extension unit. Label each cable with masking tape for
Step 2
identification as it is removed.
See
Use the screwdriver to remove the two screws that attach the extension unit and remove the unit from
Step 3
the display structure.
Attach the new audio/video extension unit to its bracket, then attach the unit and bracket to the display
Step 4
structure. See
OL-14521-01
Remove the screws from the light fixture holding bracket. The bracket is located in the middle of
the fixture. Retain the screws.
Lift the light fixture up and out of the lower cup bracket.
Using the step stool or a small step ladder, reach over the display and remove the two screws from
the light fixture holding bracket. The bracket is located in the middle of the fixture.
Lift the light fixture up and out, being careful the cable does not mar the surface of the display.
Chapter 5, "Building the Lighting Assembly"
Chapter 9, "Routing Power and Signal Cables"
Medium Phillips head screwdriver (for attaching the unit to its bracket)
Large Phillips head screwdriver (for attaching the unit and bracket to the display structure)
Masking tape
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
The auxiliary control unit on the center display structure
Chapter 9, "Routing Power and Signal Cables"
Figure 8-12 and
Replacing the Audio/Video Extension Unit—Part Number CTS-AV-EXP=
for more information.
for more information.
for additional information.
Figure 8-13 for more information.
Cisco TelePresence System 3200
12-23