Replacing a Codec Unit—Part Number CTS-CODEC-PRI-G2= (Primary Codec) or CTS-CODEC-SEC= (Secondary Codec)
Step 10
Reattach the projector screen.
Tip
The projector screen comes with printed instructions that should assist you with replacing it. If you
cannot find the instructions, reverse the order of removal to install it.
Perform the speaker adjustment procedure. See the
Step 11
Replacing a Codec Unit—Part Number CTS-CODEC-PRI-G2=
(Primary Codec) or CTS-CODEC-SEC= (Secondary Codec)
Required Information, Tools, and Equipment
To remove and replace a codec unit for the Cisco TelePresence 3200, you need the following
information, tools, and equipment:
•
•
Tip
•
•
•
•
Removing and Replacing a Codec
Note
Make sure to retain all screws, connectors, and other parts during the disassembly.
Step 1
Power off the system by completing turning off the following units:
•
•
•
Caution
Make sure all system power is turned off before beginning this disassembly.
Cisco TelePresence System 3200
12-16
Cisco TelePresence System Release 1.4 Administrator's Guide, OL-13676-03
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
A round-head Allen bit allows the bit to work at an angle instead of only straight out, which is
helpful in tight spots.
Manual screwdrivers, Phillips and flat head types
Metric wrenches, 10 to 15 mm
Masking tape
Laptop computer attached to the network
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
The auxiliary control unit on the center display structure
Chapter 12
"Setting Up the Speakers" section on page
Field-Replaceable Unit Guide
10-18.
OL-14521-01