Cisco 3200 Use And Care Manual page 185

Chapter 10 First-Time Setup
Figure 10-2
Tip If the IP address that displays is 192.168.100.2, the CTS 3200 could not contact the DHCP server or your
system does not use DHCP. If your network does not use DHCP, navigate to Configuration > IP
Settings, change the DHCP Enabled setting to No, and specify a static IP address, subnet mask, gateway
and DNS server. You must reboot your codec after you configure a static IP address.
Note
After successful bootup, the CTS Administration Software loads. When CTS Administration Software
Step 3
loading is complete, the Cisco IP telephone displays a welcome message, which displays the IP address
from which you will be able to access the CTS Administration software. The welcome screen only
appears the first time the system is booted up after initial installation or after a factory reset.
The telephone will not be registered at this time. It will show a directory number of 7000 but the
Note
telephone will not function as a telephone at this time.
Step 4 Make a note of the IP address that appears on the display. You use this IP address to log in to the Cisco
TelePresence System administration console.
Step 5 If you have not already done so, configure the Cisco Unified Communications Manager GUI. For
detailed instructions to configure Cisco Unified Communications Manager for use with your CTS 3200,
refer to the
System
From the Cisco IP telephone welcome page, press Next. The system reboots.
Step 6
The system might reboot several times during the initial startup process.
Note
OL-14521-01
System IP Address
Cisco Unified Communications Manager Installation Guide for the Cisco TelePresence
for your software release.
Loading CTS Administration Software
Cisco TelePresence System 3200
10-3