Starting The Software Setup - Cisco 3200 Use And Care Manual

Chapter 10 First-Time Setup
This section describes the procedures you make to set up the camera and includes the following topics:
•
•
•

Starting the Software Setup

To start the software setup, complete the following steps.
Step 1 Assemble the Large Camera Target.
When you slide the Camera target into the frame, make sure the target is centered in the frame between
the vertical lines at the top and bottom of the target.
OL-14521-01
"Starting the Software Setup" section on page 10-7
"Adjusting the Zoom" section on page 10-9
"Focusing the Camera" section on page 10-12
Setting Up CTS Components
Cisco TelePresence System 3200
10-7