Replacing A Second Row Table Top Section; Required Information, Tools, And Equipment - Cisco 3200 Use And Care Manual

Replacing a Second Row Table Top Section

Step 18 Insert the draw bolts or cam locks and tighten them between the new table top section and the adjoining
table top sections. See
bolts or cam locks.
Attach the legs to the table top sections with the screws. See
Step 19
Assembly"
Reconnect the microphone to the new table top section.
Step 20
Route the microphone cable to the audio/video extension unit and connect the cable to the unit.
Step 21
See
Step 22 Close the table door.
Step 23 If you removed the table door, replace the door.
See
Replacing a Second Row Table Top Section
Complete these steps to replace a second row table top section.

Required Information, Tools, and Equipment

To remove and replace a second row table top, you need the following tools:
•
•
A 10 mm open end ratcheting wrench is useful to loosen and tighten the draw bolts or cam locks.
Tip
•
Note
Make sure to retain all screws, connectors, and other parts during the disassembly.
Note
Cisco TelePresence System 3200
12-32
Chapter 6, "Building the First Row Table Assembly"
for the location of the table legs and screw attachment locations.
Figure 6-13 for microphone installation instructions.
Figure 6-14 for table door installation instructions.
Medium and large Phillips screwdriver
10 mm wrench
Furniture sliders (recommended but not required)
Furniture sliders are flat plastic pieces that you place under the table legs before you move the
table. Using furniture sliders can make moving the second row table easier.
Chapter 12 Field-Replaceable Unit Guide
for the location of the draw
Chapter 6, "Building the First Row Table
OL-14521-01