Cisco 3200 Use And Care Manual page 229

Chapter 12 Field-Replaceable Unit Guide
c. Alternately, if the fit is too tight to remove in this manner, remove the mounting screws from the
tabletop. Ensure the projector assembly is secured while removing the screws.
See Chapter 6, "Building the First Row Table Assembly"
Table Assembly"
Step 3 Disconnect the microphone from the microphone extension cable.
The microphone has a cable that is approximately three feet (1 meter) in length.
Step 4 From the underside of the tabletop, remove the two screws and washers that secure the microphone.
Retain the screws and washers.
Note
Step 5 Pull the microphone cable through the hole in the table and set the microphone aside.
Route the cable for the replacement microphone through the hole in the tabletop.
Step 6
From the underside of the tabletop, attach the microphone using the screws and washers.
Step 7
Connect the microphone extension cable to the microphone.
Step 8
Power on the system by turning the power switches to the On position on the two left PDUs, single right
Step 9
PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.
Open a browser on a computer connected to the network.
Step 10
Type in the IP address of the Primary codec. Enter the required information at the login screen. The
Step 11
Cisco TelePresence Administrator window appears.
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
Step 12
window) is Enabled/Up.
Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
Step 13
properly.
Refer to the
information.
Step 14 If required, reattach the projector assembly.
See Chapter 8, "Assembling the Remaining Cisco TelePresence Elements"
Perform the microphone test to verify that the microphone is working properly.
Step 15
See the
OL-14521-01
for more information.
Cisco TelePresence System Administrator's Guide
"Setting Up the Microphones" section on page 10-18
Replacing a Microphone—Part Number CTS-MIC=
and Chapter 7, "Building the Second Row
for your software release for more
for more information.
for more information.
Cisco TelePresence System 3200
12-21