Table of Contents
Advertisement
CENTRAL STATION
1=PRIMARY
2=SECONDARY
3=REPORT STYLE
POINT
Central Station Screen #2
ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=MANUAL DIAL MODE
On Board DACT Screen #2
MS-9050UD PN 52413:C 01/23/08
Report Style
Pressing 3 while viewing Central Station Screen #2 will cause the Report Style display to toggle
between Point and Zone. Setting the Report Style to Point will program the DACT to report
individual point status to the Central Station. The control panel is capable of monitoring a total
of 50 addressable devices. Setting the Report Style to Zone will program the DACT to report
zone status to the Central Station. The control panel is capable of monitoring a total of 20
individual zones.
Notes:
1. Detector/Module Address 01 will be reported to the Central Station as Point 01, Detector/
Module Address 02 as Point 02, with reports continuing in a similar fashion up to Detector/
Module Address 50 which will be reported as Point 50.
3.6.9.2.6 Manual Dial Mode
Pressing 3 while viewing On Board DACT Screen #2 will cause the following screen to be
displayed:
MANUAL DIAL MODE
1=PRIMARY PHONE
2=SECONDARY PHONE
Note that Manual Dial Mode cannot be entered while the panel is communicating with the
Central Station. Pressing 1 for Primary Phone or 2 for Secondary Phone will display the
following screen:
MANUAL DIAL MODE
1=GO OFF HOOK
2=DIAL DIGIT(S)
3=GO ON HOOK
Pressing 1 for Go Off Hook will cause the DACT to access the selected phone line (similar to
taking the phone handset off the cradle). The selected phone line's red Active LED will turn on.
Pressing 2 for Dial Digit(s) will display a screen which allows the user to key in the phone
number to be dialed. The first digit is keyed in and then the right arrow key is pressed to move
the cursor to the next position. The next digit is keyed in and the process is repeated until all
digits have been entered. Pressing the Enter key will cause the number just entered to be dialed.
Note: It is not necessary to go off-hook prior to dialing. Pressing the Enter key in Dial Digit
mode will cause the panel to automatically go off-hook prior to dialing.
Pressing 3 for Go On Hook will cause the DACT to hang-up, deselecting the previously
selected phone line. The phone line's red Active LED will turn off.
Programming
133
Advertisement
Table of Contents
