Zones - Honeywell Fire-Lite Alarms MS-9050UD Manual

Pressing the down arrow key, while viewing the screen shown above, will allow the operator to
view additional programming information about the selected device, such as:

4.22.2 Zones

READ STATUS
Pressing 2 while viewing Read Status Screen #1 will cause the following screens to be displayed:
1=SYSTEM POINT
2=ZONES
3=POWER
Read Status Screen #1
From the preceding screens, the control panel operator can view:
MS-9050UD PN 52413:C 01/23/08
• Enable/Disable Status
• Device Type
• Alarm Verification On/Off (for detectors)
• Walktest Yes/No
• PAS (Positive Alarm Sequence) Yes/No (for detectors only)
• Pre-Signal Yes/No (for detectors and monitor modules)
• Zone Assignments (five maximum)
• Adjective/Noun descriptor
• Silenceable Yes/No (for control modules)
1=ZONES INSTALLED
2=ZONES ENABLED
3=ZONES DISABLED
1=SPECIAL PURPOSE
2=ZONE TYPE
3=FUTURE USE
• Zones Installed - all software zones programmed into the system (20 maximum)
• Zones Enabled - all software zones that are enabled
• Zones Disabled - all software zones that have been disabled
• Special Purpose - on or off programming for Special Purpose Zones 17 reserved for PAS, 18
reserved for Pre-signal and 19 reserved for Two Stage Operation
• Zone Type - the Type assigned to each installed zone (default is Alarm)
ZONES
Zones Screen #1
ZONES
Zones Screen #2
Operating Instructions
161