Table of Contents
Advertisement
Canadian Application
H.2 AC Power Connections for Canadian Applications
For Canadian applications, an AC terminal block is supplied standard with the MS-9050UDC. The
AC terminal block is factory installed on the bottom left of the circuit board chassis.
CAUTION! Turn off all power (AC & DC) before making any connections.
Refer to the following illustrations for location and wiring information.
AC Terminal Block
Ground wire to FACP backbox Earth Ground stud
206
FACP Chassis
transformer
connections
Figure H.3 AC Terminal Block Connections
CAUTION! Make certain that all
AC Hot
power (AC & DC) has been turned
off before making any connections.
AC Neutral
Connect wires from AC main to
AC Ground
terminal block as shown.
MS-9050UD PN 52413:C 01/23/08
Advertisement
Table of Contents
