Table of Contents
Advertisement
Programming
CENTRAL STATION
1=PRIMARY
2=SECONDARY
3=REPORT STYLE
POINT
Central Station Screen #2
ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=MANUAL DIAL MODE
On Board DACT Screen #2
114
Report Style
Pressing 3 while viewing Central Station Screen #2 will cause the Report Style
display to toggle between Point and Zone. Setting the Report Style to Point will
program the DACT to report individual point status to the Central Station. The
control panel is capable of monitoring a total of 198 addressable devices. Setting
the Report Style to Zone will program the DACT to report zone status to the Central
Station. The control panel is capable of monitoring a total of 99 individual zones.
Notes:
1. Detector Address 01 will be reported to the Central Station as Point 01,
Detector Address 02 as Point 02, with reports continuing in a similar fashion all
the way up to Detector Address 99 which will be reported as Point 99.
2. Module Address 01 will be reported to the Central Station as Point 160,
Module Address 02 will be reported to the Central Station as Point 161, with
reports continuing in a similar fashion all the way up to Module Address 99
which will be reported as Point 258.
3.6.9.2.7 Manual Dial Mode
Pressing 3 while viewing On Board DACT Screen #2 will cause the following
screen to be displayed:
MANUAL DIAL MODE
1=PRIMARY PHONE
2=SECONDARY PHONE
Pressing 1 for Primary Phone or 2 for Secondary Phone will display the following
screen:
MANUAL DIAL MODE
1=GO OFF HOOK
2=DIAL DIGIT(S)
3=GO ON HOOK
Pressing 1 for Go Off Hook will cause the DACT to access the selected phone line
(similar to taking the phone handset off the cradle). The selected phone line's red
Active LED will turn on.
Pressing 2 for Dial Digit(s) will display a screen which allows the user to key in the
phone number to be dialed. The first digit is keyed in and then the right arrow key
is pressed to move the cursor to the next position. The next digit is keyed in and the
process is repeated until all digits have been entered. Pressing the Enter key will
cause the number just entered to be dialed.
Pressing 3 for Go On Hook will cause the DACT to hang-up, deselecting the
previously selected phone line. The phone line's red Active LED will turn off.
Master Programming Level
MS-9200UDLS PN 52750:A 11/04/05
Advertisement
Table of Contents
