12 Web Client Operation; Logging In; Preparing To Use The Device Web Client - Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide

12 Web Client Operation

This chapter describes how to access Honeywell's Performance Series Network Video
Recorder remotely using a browser-based web client.
This chapter is intended for remote users of the NVRs.

Logging In

This chapter includes:
• PC requirements for the web client software
• Logging in to the web client software
• The web client software's main page

Preparing to Use the Device Web Client

PC Requirements
Table 12-1 PC Requirements
Component
Processor
System memory (RAM)
Non-integrated video card
Before You Log In
Ensure that the following conditions are met:
• Ensure that the network connection is good.
Ensure that the NVR and PC network setup is correct. See the network setup: Main Menu
•
 Setting  Network.
Ping to ensure that the network connection is good. Ping *** *** *** *** (where *** *** *** ***
•
is the NVR's IP address). The return TTL should be less than 225.
Before you uninstall the web control, close all web pages. If you do not, then the
Note
uninstallation procedure might result in an error.
146
Minimum Requirement
Quad core
2G or higher
256M or higher