Honeywell Performance Series User Manual page 216

Performance Series Network Video Recorder User Guide
Delay
Alarm Out
Latch
PTZ Activation
Tour
Snapshot
Voice Prompts
Show Message
Send Email
Alarm Upload
Buzzer
Message
Log
Configuring Network Alarms
202
Note: You need to set the alarm recording period. Go to Storage 
Schedule  Record to configure the current channel for scheduled
recording.
The system can delay recording for a specified amount of time after an
alarm has ended. Select from 10s to 300s.
Select the device output port, 1 or 2. Select the corresponding port(s)
so the system can activate the corresponding alarm devices when an
alarm occurs.
The system can delay the alarm output for a specified time after an
alarm ends. The value ranges from 1s to 300s.
When PTZ activation is configured, the system can activate PTZ
operation when an alarm is detected.
1. Click Setup to open the PTZ Activation configuration interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click OK.
Click to enable a tour to be triggered by an alarm. The system supports
1/8-window tour. See Configuring Display Settings
interval setup. On the Display Settings tab, when there are two tours
enabled by default, you can configure the system so an alarm triggers
the system to enable the alarm tours you configured here. If there is no
alarm, then the system uses the tour setup that was configured in the
Display interface.
Click to enable the Snapshot function. Channel snapshots are taken
according to the schedule you configure. Alarm snapshots are taken
when an alarm occurs.
Select the check box to enable the playing of a voice prompt audio file
when the alarm is detected. Use the File Name drop-down list to select
the audio file to play when the alarm is detected.
Click to enable a pop-up message on your local host PC screen to let
you know an alarm has occurred.
The system can send an email when an alarm is detected. When you
have enabled the Snapshot function, the system can also send an
image attached to the email. Go to NetworkEmail to configure the
email settings.
Enable this function, and when an alarm event is detected, an alarm
message is uploaded to the NVR.
Click to enable the Buzzer function. When an alarm occurs, the buzzer
beeps.
Select the check box to send a text message when alarm events are
detected. Go to Network3GMobile to configure messaging
settings.
Select the check box to enable logging of alarm events.
on page 217 for tour