Honeywell Performance Series User Manual page 210

Performance Series Network Video Recorder User Guide
The configuration for Camera Scene Change Detection is very similar to the configuration for
Motion Detection. Please see
information.
Configuring Face Detection
The face detection feature analyzes the video to detect if there are any human faces
appearing in the video. If a face appears it will capture the face with either snapshots,
recordings, or alarms so it can be processed or analyzed further.
1. Go to Setup  Event  Face Detection.
Figure 12-67 Face Detection Configuration Interface
2. Select the Channel to configure for face detection from the drop-down menu and check
the Enable check box.
3. Click Draw Target to draw the Min/Max Size of a face that will trigger face detection in the
video. Use the mouse to drag and resize the Min and Max size boxes in the video image.
4. The configuration of Face Detection options is very similar to the configuration for
Motion Detection. Please see
information on setting time periods and event actions.
Face Overtemperature: Click to enable the face overtemperature function. When the
temperature of face reached the set value, an alarm will occur.
Alarm Temp Threshold: Enter a value between 0-250.
The face overtemperature function is only available for cameras that support
Note
this function.
5. Click OK to save the settings.
196
Motion Detection Configurations
Motion Detection Configurations
on page 190 for more
on page 190 for more