Configuring Alarm Input Settings; Configuring Ipc External Alarms - Honeywell Performance Series User Manual

Figure 8-12 Username Abnormality Configuration Tab
2. On the Username tab, in the Event Type box, select the event type for which you want to
configure.
3. Select the Enable check box to enable username error detection for the selected event
type.
4. Select the actions that you want the system to initiate when the selected event occurs:
Alarm Out: Select the check box to activate the selected alarm output(s) (1 or 2). In the
Latch box, specify the amount of time (0–300 s) to delay the alarm output signal after the
network event is triggered.
Send Email: Select the check box to enable the system to send an email notification. To
set up Email settings, see
Voice Prompts: Select the check box to enable the playing of a voice prompt audio file
when a network event is triggered. Use the File Name drop-down arrow to select the audio
file to play for network events.
Buzzer: Select the check box to activate a buzzer noise at the NVR.
Log: Select the check box to enable logging of network events.
5. Click Apply to save your settings.

Configuring Alarm Input Settings

Configuring IPC External Alarms

To configure IPC external alarms
1. Go to Main Menu  SETTING  EVENT  ALARM  IPC Ext.
Configuring Email Settings
Configuring Event Settings
on page 68.
89