Configuring Network Event Settings - Honeywell Performance Series User Manual

Figure 8-10 HDD Abnormality Configuration Tab
1. On the HDD tab, in the Event Type box, select the event type that you want to configure
settings for: No HDD, HDD Error, No Space. If you select the No Space event, you can
specify how low the HDD space will get before triggering the event in the Less Than field.
2. Select the Enable check box to enable HDD event detection for the event type selected.
3. Select the actions that you want the system to initiate when the selected event occurs:
Alarm Out: Select the alarm output(s) (1 or 2) that you want to activate. In the Latch box,
specify the amount of time (0–300 s) to delay the alarm output signal after the HDD event
is triggered.
Show Message: Select the check box to enable a pop-up message on your local host PC.
Alarm Upload: Select the check box to enable the system to upload an alarm signal to the
network (including to an alarm center and/or web client).
Send Email: Select the check box to enable the system to send an email notification. To
set up Email settings, see
Voice Prompts: Select the check box to enable the playing of a voice prompt audio file
when an HDD event is triggered. Use the File Name drop-down arrow to select the audio
file to play for HDD events.
Buzzer: Select the check box to activate a buzzer noise at the NVR.
Log: Select the check box to enable logging of HDD events.
4. Click Apply to save your settings.

Configuring Network Event Settings

1. Go to Main Menu  SETTING  EVENT  ABNORMALITY  Network.
Configuring Email Settings
Configuring Event Settings
on page 68.
87