Configuring The Snapshot Recording Schedule - Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
8. Click or drag the mouse in the scheduling table to set the recording period. To erase a
recording period, click the eraser icon (
day of the week that you want to configure, click the gear icon at the right of the table. In
the Period window, set up to six recording periods. To copy the settings to additional days,
select the appropriate check box(es) under Copy, and then click OK.
9. Click Apply to save your settings.
10. To copy the recording schedule settings to additional channels, click Copy, select the
channels to which you want to copy the settings, and then click OK.

Configuring the Snapshot Recording Schedule

Follow these steps to configure the snapshot recording function. When enabled, the NVR can
take snapshots when a motion detection, video loss, video tampering, or other alarm event
occurs. See Chapter 8, Configuring Event Settings
To configure the snapshot recording schedule
1. Go to Main Menu  SETTING  STORAGE  SCHEDULE Snapshot, the following
window is displayed:
Figure 4-3 Snapshot Schedule Settings
2. On the Snapshot tab, in the Channel box, select the channel (camera) for which you want
to configure a snapshot schedule.
3. At the top of the scheduling table, select the check box(es) of the recording type(s) that
you want to schedule:
General: The regular recording schedule is indicated by a green bar.
Motion: The motion detection recording schedule is indicated by a yellow bar.
Alarm: The alarm recording schedule is indicated by a red bar.
MD&Alarm: The motion detection and alarm schedule is indicated by a blue bar.
Analytics: The video analytics schedule is indicated by an orange bar.
POS: The POS schedule is indicated by a light blue bar.
40
) at the right of the table. Alternatively, for the
for detailed instructions.