Honeywell Performance Series User Manual page 181

The NVR system supports active control frame function (ACF), which
allows you to record in different frame rates.
For example, you can use a high frame rate to record important events,
and configure a lower frame rate for recording scheduled events. ACF
allows you to set different frame rates for motion detection recording
and alarm recording.
Video Enable Click to enable the extra video stream. Enabled by default.
Compression The NVR supports H.264, H.265 and MJPEG. compressions.
The NVR system supports various resolutions, which you can select
from a drop-down list.
Resolution
Note The selection is different for each NVR series and the camera that
is connected.
PAL: 1 to 25 fps
Frame Rate
NTSC: 1 to 30 fps
Select either CBR (constant bit rate) or VBR (variable bit rate).
Note If your device is connected to the NVR through ONVIF, then you
Bit Rate Type
can not select VBR. If your device is connected to the NVR through a
private protocol, then you can select either CBR or VBR.
Image Quality
If the bit rate type is set to VBR, select a value between 1 and 6.
Set to a value within the Reference Bit Rate range. To enter a bit rate
Bit Rate
that does not appear on the list, click Customized.
Watermark
Allows you to verify that the video has not been tampered.
Enable
Enter the text for the watermark. The default watermark is DigitalCCTV.
Watermark String
The maximum text length is 85 characters. You can use only letters,
numbers, and an underline.
Configuring Snapshot Settings
Go to SETUP  IMAGE  ENCODE Snapshot. After making any Snapshot changes, click
OK to save the changes.
Figure 12-32 Snapshot Settings Interface
Web Client Operation
167