Honeywell Performance Series User Manual page 207

6. Click OK to save the configurations. Click Cancel to exit the setup
The system automatically starts recording selected channels when a
motion detection alarm occurs. Click Setup to select the channel(s) to
record.
Record Channel
Note: You need to set the motion detection recording period. Go to
StorageScheduleRecord to configure the necessary channel(s) for
scheduled motion detection recording.
The system can delay recording for a specified amount of time after an
Delay
alarm has ended. Select from 10s to 300s.
Select the device output port, 1 or 2. Select the corresponding port(s)
Alarm Out
so the system can activate the corresponding alarm devices when a
motion detection event occurs.
The system can delay the alarm output for a specified time after an
Latch
alarm ends. The value ranges from 0s to 300s.
When PTZ functions are configured, the system can activate a PTZ
operation when a motion event is detected.
1. Click Setup to open the PTZ Activation configuration interface.
PTZ Activation
2. Select a preset, tour, or pattern to perform from the drop-down
3. Click OK.
Select the Tour check box and click Setup to enable a tour to be
triggered by a motion event. The system supports 1/8-window tour. On
the Display Settings tab, when there are two tours enabled by default,
Tour
you can configure the system so an alarm triggers the system to enable
the alarm tours you configured here. If there is no alarm, then the
system uses the tour setup that was configured in the Display
interface.
Click to enable the Snapshot function. Channel snapshots are taken
Snapshot according to the schedule you configure. Alarm snapshots are taken
when an alarm occurs.
Select the check box to enable the playing of a voice prompt audio file
Voice Prompts when motion is detected. Use the File Name drop-down list to select
the audio file to play when motion is detected.
Click to enable a pop-up message on your local host PC screen to let
Show Message
you know an alarm has occurred.
The system can send an email when an alarm is detected. When you
have enabled the Snapshot function, the system can also send an
Send Email
image attached to the email. Go to NetworkEmail to configure the
email settings.
Enable this function, and when a motion event is detected, an alarm
Alarm Upload
message is uploaded to the NVR.
Click to enable the Buzzer function. When an alarm occurs, the buzzer
Buzzer
beeps.
without saving the changes.
menu. Enter the preset/tour/pattern number in the field.
Web Client Operation
193