Add Call Park On A Key Expansion Module Line Key - Cisco 8800 Series Manual

Cisco IP Phone Accessories
• nme= XXXX is the name displayed on the phone for the speed-dial line key. Replace XXXX with a
You can also configure the parameter in the configuration file (cfg.xml) by entering a string in the following
format:
fnc=xml;url=http://xml.service.url;nme=name
Step 4 Click Submit All Changes.

Add Call Park on a Key Expansion Module Line Key

You can add call park to a Key Expansion Module line key to enable the user to temporarily store calls to the
same phone to which the Key Expansion Module is connected or to store calls to a different phone. The user
can also unpark the call from the line key.
Before you begin
Access the phone administration web page. See
Procedure
Step 1
Select Voice > Att Console.
Step 2 Select a Key Expansion Module line key on which to enable the call park.
Step 3
Enter a string in this format:
For a private line, enter
fnc=park;sub=$USER@$PROXY;nme=CallPark-Slot1
For a shared line, enter
fnc=prk;sub=$USER@$PROXY;nme=Call-Park1;orbit=<DN of primary line>
where:
• fnc= prk means function=call park
• sub= 999999 is the phone to which the call parks. Replace 999999 with a numbers.
• nme= XXXX is the name displayed on the phone for the call park line key. Replace XXXX with a name.
You can also configure the line-specific parameter in the configuration file (cfg.xml). Enter a string in the
following format:
<Unit_1_Key_1_ ua="na">fnc=prk;sub=$USER@$PROXY;nme=CallPark-Slot1</Unit_1_Key_1_>
Step 4 Click Submit All Changes.
name.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
Add Call Park on a Key Expansion Module Line Key
Access the Phone Web Interface, on page 104.
489