Profile Resync Parameters - Cisco 8800 Series Manual

Profile Resync Parameters

If the resync operation fails for any reason, such as if the server is not responding, the unit waits (for the
number of seconds configured in Resync Error Retry Delay) before it attempts to resync again. If Resync
Error Retry Delay is zero, the phone does not try to resync after a failed resync attempt.
Step 8 (Optional) Set the value of Resync Error Retry Delay field to a small number, such as 30.
<Resync_Error_Retry_Delay>30</Resync_Error_Retry_Delay>
Step 9
Disable the TFTP server, and observe the results in the syslog output.
Profile Resync Parameters
The following table defines the function and usage of the profile resync parameters in the Configuration
Profile section under the Voice > Provisioning tab in the phone web page. It also defines the syntax of the
string that is added in the phone configuration file (cfg.xml) with XML code to configure a parameter.
Parameter
Provision Enable
Resync On Reset
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
48
Description
Allows or denies configuration profile resync actions.
• In the phone configuration file (cfg.xml) with XML, enter a string in this format:
<Provision_Enable ua="na">Yes</Provision_Enable>
• On the phone web page, set this field to Yes to allow resync actions, or No to
block resync actions.
Default: Yes
Specifies whether the phone resynchronizes configurations with the provisioning server
after power-up and after each upgrade attempt.
• In the phone configuration file (cfg.xml) with XML, enter a string in this format:
<Resync_On_Reset ua="na">Yes</Resync_On_Reset>
• On the phone web page, set this field to Yes to allow resync on power-up or
reset, or No to block resync on power-up or reset.
Default: Yes
Cisco IP Phone Provisioning