Cisco 8800 Series Manual page 196

Add Distinctive Ringtone
Procedure
In a ring tone script, assign a name for the ring tone and add the script to configure a distinctive ringtone in
the format:
n=ring-tone-name;h=hint;w=waveform-id-or-path;c=cadence-id;b=break-time;t=total-time
where:
n = ring-tone-name that identifies this ring tone. This name appears on the Ring Tone menu of the phone. The
same name can be used in a SIP Alert-Info header in an inbound INVITE request to tell the phone to play the
corresponding ring tone. The name should contain the same characters allowed in a URL only.
h = hint used to SIP Alert-INFO rule.
w = waveform-id-or-path which is the index of the desired waveform to use in this ring tone. The built-in
waveforms are:
• 1 = Classic phone with mechanical bell
• 2 = Typical phone ring
• 3 = Classic ring tone
• 4 = Wide-band frequency sweep signal
You can also enter a network path (url) to download a ring tone data file from a server. Add the path in this
format:
w=[tftp://]hostname[:port]/path
c = is the index of the desired cadence to play the given waveform. 8 cadences (1–8) as defined in <Cadence
1> through <Cadence 8>. Cadence-id can be 0 If w=3,4, or an url. Setting c=0 implies the on-time is the
natural length of the ring tone file.
b = break-time that specifies the number of seconds to break between two bursts of ring tone, such as b=2.5.
t = total-time that specifies the total number of seconds to play the ring tone before it times out.
In the phone configuration XML file (cfg.xml), enter a string in this format:
<!-- Ringtone -->
<Ring1 ua="na">n=Sunrise;w=file://Sunrise.rwb;c=1</Ring1>
<Ring2 ua="na">n=Chirp 1;w=file://chirp1.raw;c=1</Ring2>
<Ring3 ua="na">n=Chirp 2;w=file://chirp2.raw;c=1</Ring3>
<Ring4 ua="na">n=Delight;w=file://Delight.rwb;c=1</Ring4>
<Ring5 ua="na">n=Evolve;w=file://Evolve.rwb;c=1</Ring5>
<Ring6 ua="na">n=Mellow;w=file://Mellow.rwb;c=1</Ring6>
<Ring7 ua="na">n=Mischief;w=file://Mischief.rwb;c=1</Ring7>
<Ring8 ua="na">n=Reflections;w=file://Reflections.rwb;c=1</Ring8>
<Ring9 ua="na">n=Ringer;w=file://Ringer.rwb;c=1</Ring9>
<Ring10 ua="na">n=Ascent;w=file://Ascent.rwb;c=1</Ring10>
<Ring11 ua="na">n=Are you there;w=file://AreYouThereF.raw;c=1</Ring11>
<Ring12 ua="na">n=Chime;w=file://Chime.raw;c=1</Ring12>
<Silent_Ring_Duration ua="na">60</Silent_Ring_Duration>
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
176
Cisco IP Phone Configuration