Table of Contents
Advertisement
1.1 Introduction
The LPC2141/2/4/6/8 microcontrollers are based on a 32/16 bit ARM7TDMI-S CPU with
real-time emulation and embedded trace support, that combines the microcontroller with
embedded high speed flash memory ranging from 32 kB to 512 kB. A 128-bit wide
memory interface and a unique accelerator architecture enable 32-bit code execution at
the maximum clock rate. For critical code size applications, the alternative 16-bit Thumb
mode reduces code by more than 30 % with minimal performance penalty.
Due to their tiny size and low power consumption, LPC2141/2/4/6/8 are ideal for
applications where miniaturization is a key requirement, such as access control and
point-of-sale. A blend of serial communications interfaces ranging from a USB 2.0 Full
Speed device, multiple UARTS, SPI, SSP to I
make these devices very well suited for communication gateways and protocol converters,
soft modems, voice recognition and low end imaging, providing both large buffer size and
high processing power. Various 32-bit timers, single or dual 10-bit ADC(s), 10-bit DAC,
PWM channels and 45 fast GPIO lines with up to nine edge or level sensitive external
interrupt pins make these microcontrollers particularly suitable for industrial control and
medical systems.
1.2 Features
User manual
UM10139
Chapter 1: General information
Rev. 01 — 15 August 2005
•
16/32-bit ARM7TDMI-S microcontroller in a tiny LQFP64 package.
•
8 to 40 kB of on-chip static RAM and 32 to 512 kB of on-chip flash program memory.
128 bit wide interface/accelerator enables high speed 60 MHz operation.
•
In-System/In-Application Programming (ISP/IAP) via on-chip boot-loader software.
Single flash sector or full chip erase in 400 ms and programming of 256 bytes in 1 ms.
•
EmbeddedICE RT and Embedded Trace interfaces offer real-time debugging with the
on-chip RealMonitor software and high speed tracing of instruction execution.
•
USB 2.0 Full Speed compliant Device Controller with 2 kB of endpoint RAM.
In addition, the LPC2146/8 provide 8 kB of on-chip RAM accessible to USB by DMA.
•
One or two (LPC2141/2 vs. LPC2144/6/8) 10-bit A/D converters provide a total of 6/14
analog inputs, with conversion times as low as 2.44 µs per channel.
•
Single 10-bit D/A converter provides variable analog output.
•
Two 32-bit timers/external event counters (with four capture and four compare
channels each), PWM unit (six outputs) and watchdog.
•
Low power real-time clock with independent power and dedicated 32 kHz clock input.
•
Multiple serial interfaces including two UARTs (16C550), two Fast I
(400 kbit/s), SPI and SSP with buffering and variable data length capabilities.
•
Vectored interrupt controller with configurable priorities and vector addresses.
•
Up to 45 of 5 V tolerant fast general purpose I/O pins in a tiny LQFP64 package.
•
Up to nine edge or level sensitive external interrupt pins available.
Rev. 01 — 15 August 2005
User manual
2
Cs and on-chip SRAM of 8 kB up to 40 kB,
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
2
C-bus
3
Advertisement
Table of Contents
