Clutch Oil Filter (Crf1000D) - Honda CRF1000 Shop Manual

dummyhead dummyhead
Check the oil filter boss [1] protrusion from the
crankcase is within the specified length as shown.
SPECIFIED LENGTH: 15.5 – 16.5 mm (0.61 – 0.65 in)
• If the oil filter boss is removed, apply locking agent
to the oil filter boss threads as shown and install it.
Clean the oil filter attaching surface of the crankcase.
Apply engine oil to new oil filter cartridge threads and
O-ring.
Install and tighten the oil filter cartridge [1] to the
specified torque using the special tool.
TOOL:
Oil filter wrench
TORQUE: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).

CLUTCH OIL FILTER (CRF1000D)

• Replace the engine oil filter when the clutch oil filter
is replaced.
Drain the engine oil (page 3-12).
Remove the following:
– Bolts [1]
– Clutch oil filter cover [2]
– O-ring [3]
– Spring [4]
– Clutch oil filter [5]
Install a new clutch oil filter with the "OUT SIDE" mark
[6] facing outside.
• Installing the oil filter backwards will result in severe
engine damage.
Apply engine oil to a new O-ring and install it to the oil
filter cover.
Install the spring and oil filter cover.
Tighten the bolts to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Fill the crankcase with the recommended engine oil
check that there are no oil leaks (page 3-12).
07HAA-PJ70101
Apply this area.
[1]
15.5 – 16.5 mm
(0.61 – 0.65 in)
[5]
[3]
[2]
[1]
[4]
MAINTENANCE
6.5 ± 1.0 mm
(0.26 ± 0.04 in)
[1]
[6]
3-13