Insulator - Honda CRF1000 Shop Manual

dummyhead dummyhead
Route the cam chain [1] through the cylinder head and
install the cylinder head [2] onto the cylinder.
Apply molybdenum oil solution to the cylinder head
bolts threads and seating surface.
Apply engine oil to the cylinder head bolt washers.
Install and tighten the cylinder head bolts [3] in a
crisscross pattern in 2 or 3 steps to the specified torque.
TORQUE: 83 N·m (8.5 kgf·m, 61 lbf·ft)
Install and tighten the 6 mm bolts [4] securely.
Install the camshaft (page 10-9).
Install the engine (page 16-10).

INSULATOR

Remove the throttle body (page 7-12).
Loosen the band screws [1] and remove the insulators
[2].
Installation is in the reverse order of removal.
• Align the insulator grooves [3] with the upper
crankcase lugs [4].
• Install the insulators with the stamped mark side
facing up.
• Make sure that the band screws is in position as
shown.
• Tighten the insulator band screws to the specified
range as shown.
CYLINDER HEAD/VALVE/CAMSHAFT
[2]
[4]
[1]
Left side: Right side:
[1] [2]
[2]
[4]
[3]
Up
12 ± 1.0 mm
(0.5 ± 0.04 in)
[1]
No.1 cylinder side:
[3]
[1]
[2]
12 ± 1.0 mm
(0.5 ± 0.04 in)
[1]
No.2 cylinder side:
10-19