Cushion Linkage Bearing Replacement - Honda CRF1000 Shop Manual

dummyhead dummyhead
REAR WHEEL/SUSPENSION
BEARING REPLACEMENT
CUSHION ARM
Remove the needle bearings (17 x 24 x 30 mm) [1] and
(20 x 26 x 20 mm) [2] using the special tools.
TOOLS:
Remover weight [3]
Remover handle [4]
Needle bearing (17 x 24 x 30 mm):
Bearing remover set, 17 mm [5] 07936-3710300
Needle bearing (20 x 26 x 20 mm):
Bearing remover set, 20 mm [5] 07936-3710600
Remove the needle bearing (17 x 24 x 17 mm) [1] using
the special tools and hydraulic press.
TOOLS:
Driver handle 15 x 280L [2]
Attachment, 22 x 24 mm [3]
Apply molybdenum disulfide grease to new needle
Never install the old
bearings rotating area.
bearing, once the
bearing has been
Install the needle bearings (17 x 24 x 17 mm) [1] and
removed, the
(20 x 26 x 20 mm) [2] with its marked side facing up to
bearing must be
the specified range using the special tools and
replaced with a new
hydraulic press as shown.
one.
TOOLS:
Driver handle 15 x 280L [3]
Attachment, 22 x 24 mm [4]
Needle bearing (17 x 24 x 30 mm):
Pilot, 17 mm [5]
Needle bearing (20 x 26 x 20 mm):
Pilot, 20 mm [5]
Install the needle bearings (17 x 24 x 30 mm) [6] with its
marked side facing up until it is flush with the cushion
arm surface using the special tools and hydraulic press.
TOOLS:
Driver handle 15 x 280L [3]
Attachment, 32 x 35 mm [4]
Pilot, 17 mm [5]
18-10
07741-0010201
07936-3710100
[4]
07949-3710001
07746-0010800
[3]
[1]
[3]
[4]/[5]
07949-3710001
07746-0010800
07746-0040400
07746-0040500
Needle bearing
(17 x 24 x 17 mm):
07949-3710001
07746-0010100
07746-0040400
[1]
[3] [5]
[1]
Needle bearings
(20 x 26 x 20 mm):
5.3 – 5.7 mm
5.8 – 6.2 mm
(0.21 – 0.22 in)
(0.23 – 0.24 in)
[2]
[1]
[2]
[6]
[2]
[2]