Bearing Ispection; Oil Clearance Inspection - Honda CRF1000 Shop Manual

dummyhead dummyhead
CRANKPIN BEARING
Do not interchange the bearing inserts. They must be
installed in their original locations or the correct bearing
oil clearance may not be obtained, resulting in engine
damage.
Remove the crankshaft (page 15-4).
BEARING INSPECTION
Check the bearing inserts [1] for unusual wear or
peeling.
Check the bearing tabs for damage.

OIL CLEARANCE INSPECTION

Clean off any oil from the bearing inserts and crankpins.
Carefully install the crankshaft [1] onto the upper
crankcase.
Set the connecting rods onto the crankpins.
Put a strip of plastigauge [2] lengthwise on each
crankpin avoiding the oil hole.
• Do not rotate the crankshaft during inspection.
Install the crankpin bearing caps [1].
• Align the I.D. code number on the crankpin bearing
caps and connecting rods.
CRANKSHAFT/PISTON/CYLINDER
[1]
[2]
[1]
[1]
Align
15-9