Transmission Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
CRANKCASE/TRANSMISSION/BALANCER
• Align the lock washer tabs with the spline washer
grooves.
• Always install the thrust washers and snap rings with
the chamfered (rolled) edge facing away from the
thrust load.
• Install the snap rings [1] so that the end gap aligns
with the groove of the splines.
• Make sure that the snap rings are fully seated in the
shaft groove after installing them.
INSTALLATION
MAINSHAFT
Install the mainshaft assembly [1] into the upper
crankcase.
Apply engine oil to the right mainshaft bearing [1].
Install the right mainshaft bearing into the upper
crankcase.
• Install the bearing into the crankcase with the
marked side facing out.
Apply locking agent to the mainshaft bearing set plate
bolts threads (page 1-20).
Install the mainshaft bearing set plate [1].
Install the mainshaft bearing set plate bolts [2] and
tighten them to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
14-24
CORRECT
[1]
CRF1000D shown:
[1]
CRF1000D shown:
[1]
CRF1000D shown:
[2]
INCORRECT
[2]
[1]